SAT-LD

Stand Alone Throttle

Easy SEIC based high idle system for select 2020+ Ford trucks and vans. InPower’s SAT-LD Throttle provides high idle engine RPM control, using blunt-cut wires, for vehicles with SEIC wiring as part of Ford’s upfitter access wiring. The SAT-LD has a blunt cut wire harness available if no SEIC connector is available for direct connect under the hood connection to available wiring. The SAT-LD has blunt-cut wires for all interfaces, including the operating mode inputs, RPM1, RPM2Charge, and the speed adjustment.

Talk to a rep

Light-Duty Ford Gas and Diesel Vehicle Throttle

Key Features:

SAT-LD Cable connects to SEIC connector on vehicles so equipped and has a fully blunt-cut harness for vehicles without
Low cost with fast and easy installation
Automatic charge protect and fixed speed modes
Adjustable RPM speed settings
LED status and diagnostic indicators
Customized functions are available

SAT-LD is SHIPPING NOW!

Specifications:

+12 volts: Sourced from SEIC connector or from fused ignition source
RPM1: +12 volts or ground as determined by software (see ordering guide)
RPM2: +12 volts or ground as determined by software (see ordering guide)
Ground: Sourced a Good Solid Battery Ground
Speed Adjust Input: Adjusts preset RPM to desired value between 900 and 3000 RPM – (SEIC Max), (chassis and engine dependent). Connect to +12V to increment, GND to decrement (50RPM/Sec)
Dimensions: 3.17 L x 1.92 W x 0.79 H inches

System Diagram: